Simple EIGRP Lab work

How to configure routing protocol with simple topology ?

EIGRP - (Enhanced Interior Gateway Routing Protocol)

Today we are going to learn about EIGRP lab work simulation in packet tracer through a simple way example shown below;

Step 1:First Create a topology like this,and configure ip address to all interfaces and PC.

Router R1, configuration

In Global configuration mode.

Always keep in mind to configure clock rate at DCE (Data Communication Equipment).we can see clock symbol at the serial interface that is DCE.


Router R2, configuration

In Global configuration mode

Router R3, configuration

In Global configuration mode

Interface fastEthernet0/0 and line protocol,changed state to up

After all ip address assigned then lights in all interfaces  become green.If anything wrong we get red then it is not connected properly.

Step 2:Now we see how to configure EIGRP routing protocols in this routers.

R1 Router,In Global Configuration mode,

R2 Router,In Global Configuration mode,

R3 Router,In Global Configuration mode,

In this screen shot shown here 200 is Autonomous System Number,it is used to grouping of routers under common administration, Routers in different Autonomous Number will not communicate with each other.So, Autonomous should be same in all routers.

Step 3:Now check the routing table by giving this command,


In Router R1,Privileged mode

In Router R2, Privileged mode

In Router R3, Privileged mode

Step 4:Now click on PC and select Desktop -> command prompt,then check connectivity between 10.0.0.10 and 40.0.0.10

We have to Ping PC0 and PC1 to check the connectivity in network.

Finally ,This is EIGRP lab simulation done in packet tracer version 7.0