Loop back Configuration

Loop back Configuration

Hi !!! Everyone today we are going to learn about Lop back Configuration in packet tracer and this is our following topology screenshot as shown below.

Configuration on Router R1:

To see Router interface IP address:

Configuration by RIP Routing on Router R1:

Now we can see RIP Routing databases on router R1:

Configure IP address on interfaces of Routers R2:

This can be our result after assigning the IP address interfaces the red changes state to up that is green.

Now we should check R2 interface IP address:

To Configure RIP Routing on Router R2: 

We can see RIP databases on Router R2:

Finally, We have to check the communication between both PCs in every interfaces by pinging IP assigned on each loopback interfaces:  

Router R1:

Router R2:

 

Therefore, We have finally completed our Loopback Configuration lab in Packet tracer v 7.0.