Wireless Communication with Access point

How to configure Wireless communication with Access point

Hi ! everyone on today we are going to learn about how to configure Wireless Network communication with Access point. Now we have to do these tasks given below to configure this wireless network.

Let us create wireless topology on packet tracer. For this go to the wireless devices and select Linksys wireless router, take some PCs and provide them with wireless Linksys module so that they can communicate through router wireless. 

For that we should go to the PC physical mode as shown in our screenshots or figures given below.

We should apply IP addresses and make the status on.

Now, we can see that the connection between Access point and the Router0 changes from red to green when the change of state to up shown in the screenshots.

We can also give Authentication key to Access point as in this figure shown below;

Now we should connect the wireless Access point with the PCs to communicate with each other. We should click PC0 in that go to desktop and click PC wireless which is shown as screenshots given below.

We can see link information shown in this screenshot stating that it is not connected. 

In this particular section after clicking connect section near link information option and we should select the network "youngccnalabtrainers" that we have already saved in our wireless Access point port 1.   

We have to click connect option and it will ask correct password we have to enter cisco12345  

After entering correct password and click connect option to check for communication with both PCs given.

Finally, we have successfully configured the wireless communication with Access point in this packet tracer version 7.0.